Roland SR-JV Cards - Urgent Fix Required

Discussions about anything analog, digital, MIDI, synth technology, techniques, theories and more.

Roland SR-JV Cards - Urgent Fix Required

Postby Tekhed66 » Fri Jun 01, 2018 1:10 am

Hi all

** all Roland SR-JV Card Users**

Not sure if you have seen this post by fellow VSE member Manny (it was buried inside a separate post):

"On a related note, I stumbled upon this thread the other day about the risks of a capacitor exploding on SRJV boards. Apparently Roland has issued a warning about the use of these boards. As I have one in a JD990 and some in a 5080 so it looks like some work is needed.
Here's the link:"

:o :o :o :o
It's quite a serious problem ... follow the link and see the damage (!!) ... the fix is easy-ish depending on your soldering ability and confidence but it's recommended that you stop using the cards and immediately for leaks... if you can, check the resistance across the 6V capacitor on an unpowered card ... if it's greater than about 0.8 Ohm then the cap has started to dry out and is at risk... don't risk that JD990!!!!!

Thanks to Manny for posting the warning.
User avatar
Junior Member
Junior Member
Posts: 155
Joined: Thu Jun 04, 2015 6:59 am
Location: Australia
Gear: Roland JD-990
Roland JD-800
Roland XV-5080
Roland SH-01A
Kurzweil K2000
Yamaha An1x
Korg Triton Rack
Korg M1
Korg Radias
Korg Volca Beats
Akai s5000
Band: The Creepy Uncles

Return to General Synthesizers

Who is online

Users browsing this forum: No registered users and 24 guests