WTB: Volume Pot For Moog MG-1

The place for parts & services: Modifications, Spare Parts and Repair Services, Sample Packs, Accessories.
Forum rules
This forum follows the same rules outlined in Gear For Sale Rules and Guidelines

Moderators have the right to edit your posts to keep them within the framework of these rules.

WTB: Volume Pot For Moog MG-1

Postby analoglsd » Thu Jul 11, 2013 8:45 am

WTB: Volume Pot For Moog MG-1
User avatar
Supporting Member!
Supporting Member!
Posts: 571
Joined: Wed Sep 03, 2008 7:53 am
Location: Oakland, CA
Real name: Lance
Gear: Buchla Music Easel, TE OP-1, Korg MS-20, Yamaha RS-7000, Effects Pedals

Re: WTB: Volume Pot For Moog MG-1

Postby celebutante » Sun Jan 19, 2014 9:41 am

If you must have a "genuine" one, knock yourself out, but I doubt there's anything unique about it. Don't know if it's a spline- or D-shaft, but I'm sure it's something very standard. I'd recommend just figuring the impedance (probably says right on it, likely 100K) and the physical size (likely 24mm) and ordering one from Mouser or Digi-key. Probably would cost $2. I found lots of info here:

synthesizers.com modular • Sequential Prophet-5 • Roland Jupiter-4 • Korg Delta • Oberheim SEM • Ensoniq SQ-80 • Korg MS-20 • Moog Minimoog • Yamaha CS-15 • Cordovox/Moog "White Elephant"

User avatar
Junior Member
Junior Member
Posts: 171
Joined: Thu May 04, 2006 7:57 am
Location: Las Vegas

Return to Gear Services & Other Goods

Who is online

Users browsing this forum: No registered users and 6 guests