Page 1 of 1

ESI4000 - Triggering a sample to play to the end

PostPosted: Thu Jan 11, 2007 6:12 am
by tiktak
So what I am looking to achieve is to use my drum pad to trigger a 3 to 6 second sample where when I hit the pad (or key) it plays the entire sample to the end.

I have owned E-MU samplers for years and have figured this out for the emax, emax II, EIII, EIIIxs/xp, but on the newer ESI4000 I simply cannot figure out how to do this or find if it is even possible to do. I have read the manual from front to back and haven't seen any mention of it. Any help would be great!

PostPosted: Thu Jan 11, 2007 8:04 am
by supermel74
I've never used an EMU sampler but I'm sure it is possible. I would think it would be something with the EG, maybe opening up the release if that makes any sense.

PostPosted: Thu Jan 11, 2007 12:28 pm
by tallowwaters
put your release all the way up.

The correct answer

PostPosted: Thu Jan 18, 2007 7:46 pm
by madtheory
There is a one shot mode. It's in Dynamic processing> Select zone> keyboard mode> set it to "trigger".

found it

PostPosted: Thu Jan 18, 2007 8:57 pm
by tiktak
To parts to make it work - First you have to be in trigger mode - Second you have to set the release to be the same amount of time as the sample being played.
Thanks everyone. It works now.

S

PostPosted: Fri Jan 19, 2007 11:31 am
by madtheory
It would be better to set the sustain time to the same length as the sample, with due regard to the pitch you've set the sample at.