Page 1 of 1

Juno-106 Sine Wave.

PostPosted: Mon Nov 20, 2006 7:17 am
by neandrewthal
I just soldered in a new lfo depth slider to replace the old broken one in my Juno-106. It works fine but now when I turn off the saw and pulse waveforms the sine wave won't sound. Does anyone have any idea how I might have screwed it up and how to fix it?

PostPosted: Mon Nov 20, 2006 9:51 am
by dougt
Uhh, what sine wave? The only sine wave it has is when the filter resonance is set to oscillate...

PostPosted: Mon Nov 20, 2006 7:20 pm
by neandrewthal
I read somewhere it was supposed to play a sine wave when the pulse wave and saw wave were turned off. Maybe what I was hearing before was just the suboscillator.

PostPosted: Mon Nov 20, 2006 7:39 pm
by memo
neandrewthal wrote:I read somewhere it was supposed to play a sine wave when the pulse wave and saw wave were turned off. Maybe what I was hearing before was just the suboscillator.


Nope - if you turn off the saw, the pulse, and turn down the suboscillator, you won't hear anything unless the resonance is at max.

If you have keytracking on max, and tune the filter cutoff when the filter is self-oscillating, you can have a playable sinewave across the keyboard.