Page 1 of 1

Question for techs regarding an ARP Solus

Posted: Fri Apr 08, 2011 4:02 pm
by maindeglorie
I really love if the LFO rate on my Solus could go higher into the insanity range, but after searching the schematics I was disappointed to not see a trim pot for the LFO. Is that right??? Usually there are always trim pots for LFO's.
So how would I go about getting a faster rate on the Solus? Change a resistor?

Re: Question for techs regarding an ARP Solus

Posted: Sat Apr 09, 2011 3:39 pm
by Steve Jones
You could experiment with the value of R54.

Re: Question for techs regarding an ARP Solus

Posted: Sun Apr 10, 2011 3:49 am
by maindeglorie
Thank you!