I've d/loaded a template and it loads into the remote sl ok.
Then it goes wierd.

twisting some of the knobs and sliders do produce a change in the sound,
eg: filterfreq (a good obvious tester) but it sounds like it just jumps to a random value then sticks it does not sweep through the filter as it should...same with resonance.
It does the jump and stick then twisting the knob does nothing again.
most knobs / sliders do nowt.
The parameters edit ok from the front panel and the keyboard triggers the synth no bother (pitch bend and mod too)
so I know the synth is working and its getting midi ok.
i'm a total newb when it comes to sysex, any ideas what I'm doing wrong?

I've searched here and the only usefull bit of info I gleaned was that clusterchord has these in his/her???

Dont really wanna PM clusterchord outta the blue though.