sh101 internal pots

FX23 · Post by **FX23** » Tue Mar 16, 2010 4:32 pm

what do the internal pots do inside the sh101, and which ones are safe to tweek without adjusting the tuning and timing?

Syn303 · Post by **Syn303** » Tue Mar 16, 2010 4:54 pm

"Ne Touche Pas" - Don't Touch, or you won't have a 101 that sounds like a 101 anymore, only adjust if you know what they exactly do and that you can put them back to the correct factory adjustment settings. Refer to the Service notes only.

Power Supply - VR1 +5V (D/A Width)

D/A Conveter - VR2: D/A Tune / VR3: D/A Linear / VR5: Range Width

VCO - VR4:Pulse Width / VR6: VCO Width / VR7: VCO Tune

VCF - VR8: VCF Width

Post by **Maschinengeist** » Tue Mar 16, 2010 5:47 pm

I second Syn303

snod_donkey · Post by **snod_donkey** » Tue Mar 16, 2010 6:14 pm

Dont do anything unless you have to... and then only do it if you have all the correct test equipment and the set up notes. Its not an easy job

FX23 · Post by **FX23** » Tue Mar 16, 2010 8:14 pm

ive descided to make some music instead!

FX23 · Post by **FX23** » Wed Mar 17, 2010 9:50 pm

sh101 internal pots

sh101 internal pots

Re: sh101 internal pots

Re: sh101 internal pots

Re: sh101 internal pots

Re: sh101 internal pots

Re: sh101 internal pots