Roland jx10 (others) display coil data

The place for parts & services: Modifications, Spare Parts and Repair Services, Sample Packs, Accessories.
Forum rules
This forum follows the same rules outlined in Gear For Sale Rules and Guidelines

Moderators have the right to edit your posts to keep them within the framework of these rules.

Roland jx10 (others) display coil data

Postby rhino » Wed Aug 01, 2012 8:53 pm

The Roland JX10 and others have a vacuum fluorescent display powered by a small transformer oscillator. Today, because of the constant 15kHz vibration of the core, wires are breaking and the display goes dark. Roland is no longer stocking this part and Sumida will not produce a run of less than many thousands of units.
I have "autopsied" a coil and posted the results for anyone with a blind JX and the patience to re-wind the transformer

Pins are numbered clockwise when seen from the pin end (foil side of board)
Windings are all clockwise when seen from the TOP end of coil

Pin 1 and 2 27 turns #34 - this is the driver winding

Pin 3 and 4 17 turns #36 - these are the center-tapped filliment
Pin 4 and 5 17 turns #36

Pin 6 and 7 8 turns #36 - this is the feedback winding
Pin 7 and 8 148 turns #36 - this is the -38-volt winding
Pin 8 and 9 36 turns #36 - this is the -43-volt winding
When the wise man points to the stars, the fool looks at the finger.
- Confucius
User avatar
Supporting Member!
Supporting Member!
Posts: 2605
Joined: Sat Aug 02, 2008 5:00 pm
Location: kentucky hills
Real name: bill
Gear: keepers:
Kurzweil K2500x
Ensoniq TS-12
Yamaha SY-99
Alesis QS-8
Roland JD-800
Roland JX-10
Akai AX-80
Ensoniq SQ-80
Korg DSS-1
Moog Mini

Re: Roland jx10 (others) display coil data

Postby paugui » Sun Dec 30, 2012 5:02 pm

Can this problem cause the screen to get extremely bright too?
My MKS-70 has this problem, all the segments get illuminated and it's just impossible to read anything...
I also noticed that the illumination also depends on the amount of segments that are supposed to be on, so if the text that was supposed to appear is really short, it is less bright than if it was a long text...

Thanks in advance

Active Member
Active Member
Posts: 355
Joined: Fri Aug 19, 2005 12:47 pm
Location: Marinha Grande, Portugal / Oslo, Norway

Return to Gear Services & Other Goods

Who is online

Users browsing this forum: No registered users and 1 guest