Hello.
I'm an electronics novice so I was wondering if somebody would be able to help me figure out how to pull off this modification I have an idea for.
What I want to do is install a poteniometer that could tune the entire range of the oscillators. That way I can tune higher and lower than the Mg-1 is capable of out of the box.
Thanks in advance.
Moog MG-1 Pitch Mod
Forum rules
This forum follows the same rules outlined in Gear For Sale Rules and Guidelines
Moderators have the right to edit your posts to keep them within the framework of these rules.
This forum follows the same rules outlined in Gear For Sale Rules and Guidelines
Moderators have the right to edit your posts to keep them within the framework of these rules.
-
Jacob Hunt
- Newbie
- Posts: 76
- Joined: Wed Mar 09, 2011 10:54 pm
- Gear: An old Polymoog that's on it's way.
- Location: The Backwoods of Georgia...
Re: Moog MG-1 Pitch Mod
I remember a far simpler mod working on the Moog Prodigy, not sure if it's the same. Anyway, there was a pin in the pitch wheel that kept the wheel from spinning too far that can be removed. This allowed it be be tuned a full octave lower, probably could have worked for higher too, I forgot by now. This really helped the Prodigy ALOT in my opinion, it was getting near Minimoog territory I thought. Maybe if you wanted to keep with your original idea then you could maybe fit another pot in line with the pitch wheel?
Anyway, good luck!
Anyway, good luck!