I'll give this question a try in this thread I suppose. When you play samples on the MPC (especially instrument samples) does the audio over lap when you hit the pads? So say if you have a chopped sample and the hits run for a few seconds each, will the sustain start to run everything together, or ...

I read somewhere, in an interview, that he uses a monomachine among other things.. elektron gear...so expensive, if thats what he uses on most his stuff i want one though, hes influenced me quite a bit yeah it's expensive... BUT TOTALLY WORTH IT! it's the best piece of ... anything that I've touche...

But i tried to help a little bit with some magic powder on the wooden hammer...it helps a little bit what's that *magic powder*? some cocaine? :lol: anyways, I've always wanted an electric piano and just the other day, I had the honours to play a Wurlitzer 200/a/ -I don't remember.. anyways, it was...

HELP... WD *DUH! :P off course..* have your tried winecountry yet. sometimes paying for it, is worth it. yeah, but it's like $50 or something + shipping and then, when it arrives, I actually have to pay 25-35%taxes+tolls :? so a .pdf would be better, I had an offer: a .pdf for $15. I think I'll go ...

you should check out the korg kpr-77, it's pretty rare, but it's analog.. put those individual outs -> eq's + filters = nicey nicey. you can get some pretty booming bass drums out of it by opening it up and tuning the BD decay put/slider more check it out, if you want analog *edit, ^this was written...

wow, no need for a new thread, really..

new threads = delete old threads (that might contain valuable info)
so be careful

tallowwaters wrote:bump

eskimo wrote:-Your milage may vary. I haven't recorded anything good in years because I'm deaf.

seriously?
are you deaf?
that's terrible

JSRockit wrote:Also, on non-bass sounds, use a low-pass filter to remove unnecessary bass.

high-pass

I read somewhere, in an interview, that he uses a monomachine among other things..

Oh man :( I just wrote a huge reply and then I get the: "Could not connect to database" blah blah blah error :cry: anyways, it was about recording everything (seperate tracks) into a computer (so you can rearrange it later if you need) and then out of the computer -> effects, maybe some compressors+...

I think that you missed the point of my second post. I'm trying to get people to start chiming in with ideas. However, your original post lacks a lot of details, which many find not only helpful but necessary to be able to start offering suggestions. Heck, I can think of loads of synths that meet t...

Oh my god, I've been looking all over for this badboy. I didn't know where else to post but here, I know machinengeist was looking for it over at the yahoo groups, but with no luck.. Does anybody have it in 21st century computer form? :) My MT is getting serviced and the service manual is needed :( ...

the coolest looking synth IMO:
pretty cheap too..
The Sequential Circuits Multi-Trak:


I got a mint/MUSEUM condition one being serviced right now

I've actually gotten a few messages from users on You Tube asking me to take down the two videos I've put up of Suicide, claiming it was not a good influence to other users...? oh my god, I hate content-cops/internet wankers, the internet doesn't have any laws, ya hear?! http://www.modelguns.co.uk/...

also, turn the filter down a lot, add an LFO on the filter cutoff (slow, not deep), with a long "pre-delay", so the sound is filtered first, then slowly starts to "LFO-filter-open" itself.. make sense? :P and yes, reverb will help a ton.. something like thosee korg/roland ambient reverbs/delays they...