Page 1 of 1
monomachine & mbase
Posted: Mon Dec 03, 2007 8:41 am
by pix
I remember reading some posts about some problems when sequencing the mbase with a monomachine but I can't find it with the search function.
does anybody knows if the problems have been fixed?
is this a good combo?
Posted: Mon Dec 03, 2007 1:31 pm
by Soundwave
My MnM works fine with my stuff tho I haven't used it with an Mbase.
Posted: Mon Dec 03, 2007 4:29 pm
by pix
I think there was a specific problem between these two. Something to do with triggering, but I can't find the original post (I think it was here on VSE).
Posted: Mon Dec 03, 2007 4:51 pm
by JSRockit
pix wrote:I think there was a specific problem between these two. Something to do with triggering, but I can't find the original post (I think it was here on VSE).
I believe that was on elektron-users.com wasn't it? I can't find it there either...but now what you're talking about. I would post there again.
Posted: Mon Dec 03, 2007 7:42 pm
by kuroichi
there was something on elektron-users forum at one point, and JM said something on the jomox group too, apparently its something to do with the elektron equipment, but not everyone gets the same problem
Posted: Mon Dec 03, 2007 10:31 pm
by pix
yeah, that was the reason for not finding it
here it is
http://www.elektron-users.com/modules/n ... SC&start=0