Anyone ever play with the CV in on a Roland SDE-3000

donaldm · Post by **donaldm** » Wed Mar 26, 2008 5:49 pm

I just bought one of these on a whim of the 'Bay (mainly because it was cheaper than a D-Two or a PCM-41). Should the CV in on it be cool to receive signals from the Patch panel on my MS20? I'm hoping to send it voltage and run the filter of the MS20 in th effects loop on the SDE.

anyways.....

Post by **Stab Frenzy** » Thu Mar 27, 2008 12:05 am

To make sure check the manual, it's available on roland's website. I would have thought that any voltage from 0-5V should be fine.

Post by **meatballfulton** » Thu Mar 27, 2008 1:04 am

Not the Roland, but I have an old DOD delay unit hat lets you modulate the delay time with a CV. It worked but I never found it all that useful, your mileage may vary.

Post by **Stab Frenzy** » Thu Mar 27, 2008 1:06 am

Oh yeah, this should be in Sound Production.

Make it so!

donaldm · Post by **donaldm** » Thu Mar 27, 2008 1:53 am

sorry, boss.

Post by **Stab Frenzy** » Thu Mar 27, 2008 2:08 am

donaldm wrote:sorry, boss.

No worries, I'm sure one of the nice General Synths mods will be along in a minute to move it. Probably Jack.

Post by **WDW** » Thu Mar 27, 2008 3:33 am

Moved.

WD