Vintage Synth Explorer Forums

read the manual in full and couldn't find any mention of where/how to assign which function (cutoff, vibrato, resonence etc.) is affected by the aftertouch

anyone know how?

Aftertouch is known as 'Pressure' on the Mopho (see page 32 in Manual). So when setting up a Modulator you need to select 'Pressure' as the Source and then pick your Destination & Amount as you like.

Pressure, velocity, modwheels etc. also have their own path, you don't need to waste a modulator on them - but you can assign additional destinations with the modulators.

pflosi wrote:Pressure, velocity, modwheels etc. also have their own path, you don't need to waste a modulator on them - but you can assign additional destinations with the modulators.

True. I should have said 'for example, when setting.....'.

thank you both!

peripheral question......is there an lfo on/off button?

i'm assuming that the "amount" knob serves this function and there's no on/off.

correct?

chimney chop wrote:thank you both!

peripheral question......is there an lfo on/off button?

i'm assuming that the "amount" knob serves this function and there's no on/off.

correct?

Alternatively, set the LFO Destination to 'OFF'

Psy_Free wrote:

chimney chop wrote:thank you both!

peripheral question......is there an lfo on/off button?

i'm assuming that the "amount" knob serves this function and there's no on/off.

correct?

Alternatively, set the LFO Destination to 'OFF'

thanks