KORG EPS-1
Posted: Thu Oct 25, 2012 12:41 pm
The tremolo is not working...I need the schematics to find which board to look at or has anyone here worked on one..?
HELP..
HELP..
Vintage Synth Explorer Forums
Synthesizer Discussion Forums
https://forum.vintagesynth.com/
KORG EPS-1
Page 1 of 1
Re: KORG EPS-1
Posted: Thu Oct 25, 2012 1:57 pm
I found the board....Can the MN3009 be used as a tremolo or just chorus...?
Re: KORG EPS-1
Posted: Fri Oct 26, 2012 9:40 pm
After poking around the board with my signal tracer it started working again...Has not failed on the bench so it's back in the studio for now....
Hmm a bit annoying that i don't know why ..But it works for now.
Hmm a bit annoying that i don't know why ..But it works for now.
Re: KORG EPS-1
Posted: Sat Oct 27, 2012 10:20 am
cold solder joint?
Re: KORG EPS-1
Posted: Sat Oct 27, 2012 8:53 pm
Cold solder joint....I don't know in this case as usually it would fail again when it's off for a while. But it keeps on working. I was tracing the signal then it worked but i can't recall where.
With schematics i might of understood more...But for now it works..
With schematics i might of understood more...But for now it works..
Re: KORG EPS-1
Posted: Sat Oct 27, 2012 8:56 pm
As a point of interest the EPS has the same string board found in the trident..